Strong SRT 8115 User Manual download pdf (Page 11)

PART 1 • English

To turn your receiver ON or to Standby, use the q button on the remote control.

Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number

with the 0~9 buttons on the remote control or press OK in viewing mode to display the channel list.

The volume can be adjusted with the tu buttons.

6.0 OPERATION

Your new receiver is equipped with several features to make watching TV a true pleasure. This

paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of

your receiver.

6.1 Changingchannels

Following ways are possible for changing channels with your new receiver:

 Via direct access using the 0~9 buttons.

 Via the channel list through OK and the PG+/PG- buttons.

 Via the pq buttons.

6.1.1 Direct access via 0~9buttons

To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the

remote control. Channel numbers can be up to four digits long. Entering a number with less than

four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or

press OK immediately after selecting the channel number.

6.1.2 Channellist

Press OK in viewing mode to display the Channel List. Use pq in the channel list to highlight your

channel of choice and press OK once to select the highlighted channel. Press OK again to leave the

channel list mode. Inside the channel list it is possible to use the PG+/PG- buttons as well in order to

scroll page-wise through the list.

TIP: Use tu to toggle between the All Channel list and favourite list(s) or press

FAV in viewing mode for a list of available favourite lists.

6.1.3 Using the pqbuttons

p switches to the next channel.

q switches to the previous channel.

6.2 InfoBanner

While watching TV you can press the INFO button at any time in viewing mode to access current

information about the channel and event*. Press INFO twice for extended EPG details about the

current channel. Press INFO three times for technical details about the current channel.

*Event information is displayed when available. Availability depends on broadcast.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

No comments

Strong SRT 8115 User Manual Page 11